Rega KYTE Mode D'emploi page 2

2
EN
ASSEMBLY
Included with your KYTEs are two rear feet
and four Pozi 2 screws. These are required
to install the rear foot on each speaker (you
will need a PZ2/Pozi 2 screwdriver). Simply
hand tighten two screws through each of the
feet into the corresponding threaded holes
on the back of the speaker (as shown in the
diagram). To ensure the foot is aligned correctly,
place the speaker with foot attached on a flat
surface before fully tightening to ensure the
speaker will sit level in its final position.
IMPORTANT: NEVER place the speaker
face down when fitting the feet to
avoid damage to the drive units.
An optional metal base is available for
purchase, which will offer greater compatibility
with a wide range of third party loudspeaker
stands (see www.rega.co.uk for details).
CONNECTION
Ensure the colour terminals Red (+) and Black
(-) are connected to the correct terminals at
both loudspeaker and amplifier binding posts.
We recommend using good quality loudspeaker
cable such as the Rega 'Duet'. Always use the
same length speaker cable to each loudspeaker.
POSITIONING
The KYTEs can be used on stands, a sturdy
shelf or flat surface. Imaging and bass response
can be tuned by adjusting the distance of
the speaker from the rear and side walls. As
with all loudspeakers, this will be dependant
on the size of room, flooring and furnishings
therefore some simple experiments trying
different distances will help optimise the
performance to your surroundings. In general
more bass is produced if the cabinet is
positioned closer to a structural wall.
www.rega.co.uk
REPLACING THE DRIVE
UNITS
In the unlikely event a drive unit needs to be
replaced it is necessary to remove the front
fascia label to access the drive unit fixing
screws. A new adhesive front panel label will
be supplied as standard with any replacement
units. To remove the front panel label, we
recommend accessing via the unit that
requires replacement to prevent damage to
the phenolic cabinet. We recommend that any
servicing is carried out via your Rega dealer.