Hinkley 80 Swell Manuel D'utilisation page 9

REMEMBER
to turn o the power before you begin.
To properly install your ceiling fan, follow the steps below.
6 Slip the blades ring, yoke cover, trim ring and canopy onto the downrod.
(Fig. 3)
7
Slide the hanger ball onto the downrod, insert the cross pin through the
downrod and tighten. Tighten the set screw.
8
Feed wires through holes in rubber ball moisture cap and slide cap down
over top of ball. (Fig. 3)
9
Lift ball/downrod/fan into hanger bracket opening.
NOTE: The tab opposite hanger bracket opening should t in slot on ball.
(Fig. 4)
NOTE:
6 feet of lead wire is supplied on the fan for use with
longer downrods.
INSTALLATION OF SAFETY CABLE SUPPORT
Attach the wood screw and the flat washer to the ceiling joist as
shown (do not fully tighten). Slide the cable clamp onto the
safety cable from the fan. Loop the safety cable around the
wood screw that was just attached to ceiling joist. Feed the end
of the cable into the clamp and pull as much cable through as
possible. Firmly tighten screw in the clamp. Cut o excess cable.
Cross Pin
Hanger ball
Set screw
Fig. 3
Wood Ceiling Joist
Safety Cable Clamp
Safety Cable Loop
Wood Screw
And Washer
Safety Cable
Fig. 4
©2019 Hinkley Lighting, Inc.
Ground Wire
Downrod
Canopy
Trim Ring
Yoke Cover
Blades Ring
Top of
Fan Body
07
| hinkley.com