Audio Setup; Audio Setup Operation; Setting The Digital Output - Alpine DVA-9861 Mode D'emploi

Audio Setup

RETURN
SETUP

Audio Setup Operation

• Audio Setup Operation is performed by the remote control unit.
The following 5 steps are common to each of the Audio Setup
settings. Refer to the specific section for details.
1
Press SETUP before inserting a disc, or when in
stop mode.
The setup menu appears on the monitor.
S E T UP
L A N G U A G E S
T V S C R E E N 1 6 9 W I D E
O F F
P A R E N T A L E N
A U D I O S E T U P
C U S T O M S E T U P
2
Press or to select "AUDIO SETUP," then press
ENT.
3
Press or to select your desired setting item,
then press ENT.
AUDIO SETUP items:
DIGITAL OUT/ DOWNMIX MODE
S E T UP
A U D I O S E T U P
D I G I T A L O U T
D O W N M I X M O D E S U R R O U
4
Press or to change the setting, then press ENT.
ENT.
N D
5
When the setting is complete, press SETUP.
The setup returns to normal mode.
• When settings are changed, old settings are overwritten. Make a note
of the current settings before making changes. If the vehicle's battery
is disconnected, the settings will be cleared and will return to the
factory settings.

Setting the Digital Output

Use the following procedure to set the digital audio signal output from
the DVA-9861.
Setting item: DIGITAL OUT
Further setting items: DOLBY D / DTS
Press or to select your desired setting item, then press
ENT.
DOLBY D: Sets Dolby Digital output.
The initial setting is BITSTREAM.
DTS: Sets DTS output.
The initial setting is BITSTREAM.
Setting contents: BITSTREAM / LPCM
Press or to select BITSTREAM or LPCM, then press
ENT.
BITSTREAM:The digital output is switched automatically
according to the type of audio signal being
played.
Be sure to select "BITSTREAM" when you
want to connect a digital audio processor and
play Dolby Digital audio. "BITSTREAM" is
selected upon shipment from the factory.
LPCM: The audio signal recorded on the disc is
converted to 48 kHz/16 bit (for DVDs) or 44.1
kHz (for video CDs and CDs) linear PCM
audio signals for output.
• Press RETURN to return to the previous screen.
29
-EN