Newage SKU Guide D'installation Et Mode D'emploi page 52

Troubleshooting
PROBLEM
4. Main burner will not light
with the igniter, but will light
with a match
5. Humming regulator.
6. Burners will not cross light
each other.
7. Burner output on "high" set-
ting is too low. (Rumbling noise
and fluttering blue flame at
burner surface.)
8. Infrared burner (if equipped)
flashes back (during operation
the burner abruptly makes a
loud "whoosh" sound, followed
by a continuous blow-torch type
sound and
grows dim.)
52
POSSIBLE CAUSES
electrode is covered by cooking residue
Clean wire or electrode using a cloth and rubbing alcohol.
Electrode and burners are wet
Wipe with dry cloth.
Ignition electrode cracked or broken; sparking where cracked
Replace the valve. This must be done by a licensed gas fitter.
Flame thrower orifice is blocked
Clean the orifice or replace the valve as required.
Faulty igniter.
Replace the valve. This must be done by a licensed gas fitter.
This is not a defect. It is caused by internal vibrations in the regulator
and does not affect the performance or safety of the gas grill. Hum-
ming regulators will not be replaced.
Grease, Food material, or Dirt build up.
Clean the fire-bridge channels. Make sure the burner's side ports are
clean.
Supply hose is pinched.
Reposition supply hose as necessary.
Dirty or clogged orifice. Spider webs or other matter in venturi
tube.
Clean burner orifice . Clean out venturi tube. refer to page 9.
Ceramic tiles overloaded with grease drippings and build-up. Ports
are clogged.
Turn burner off and allow to cool for at least two minutes. Relight burn-
er and burn on high for at least five minutes or until the ceramic tiles
are evenly glowing red.
Burner overheated due to inadequate ventilation (too much grill
surface covered by griddle or pan.)
Ensure that no more than 75% of the grill surface is covered by objects
or accessories. Turn burner off and allow to cool for at least two min-
utes, then relight.
Cracked ceramic tile.
Allow burner to cool and inspect very closely for cracks. If any cracks
are found, contact NewAge customer service for replacement option.
Leaking gasket surrounding the ceramic tile, or a weld failure in
the burner housing.