Newage SKU Guide D'installation Et Mode D'emploi page 38

Lighting the Grill
Manual Lighting
2
2
UNWIND
FROM TWO
STANDOFFS
38
Method 1(Fire Tube):
If the burners fail to light after a couple of attempts, it can be
lit using the supplied match lighting stick. Follow the steps
below for manual grill lighting.
1. Read and complete PRE-GRILL checklist.
2. Make sure all control knobs are set to off.
3. Always light grill with lid open.
4. Turn fuel supply on.
5. Place a kitchen lighter on top of the fire tube opening and
light it up
6. Push the far right control knob in and turn it to HIGH
to ignite the right burner. Check that the flame is lit by
looking through the cooking grates. You should see a
flame.
7. Once the far right burner is lit, push-in and turn the valve
for the middle burner. Once the fire crosses over and
light the middle burner, you can repeat this process for
the burner on the far left side. If any of the burners fails
to ignite during the lighting process, within five seconds,
stop, turn the burner control knob to OFF and wait five
minutes to allow the gas to clear before you try again.
Method 2 (Access Holes):
1
If the burners fail to light after a couple of attempts, it can be
lit using the supplied match lighting stick. Follow the steps
below for manual grill lighting.
1. Read and complete PRE-GRILL checklist.
2. Make sure all control knobs are set to off.
2
3. Always light grill with lid open.
4. Turn fuel supply on.
5. Place a match in the alligator clip on the match holder and
light the match.
6. Guide the match holder, with lit match, through the access
holes on the ceramic briquette tray and adjacent to the
right burner.
7. Push the corresponding control knob in and turn it to
HIGH to ignite the left burner. Check that the flame is lit
by looking through the cooking grates. You should see a
flame.
8. Repeat step 5 to 7 for the remaining burners. If any of the
burners fails to ignite during the lighting process, within
five seconds, stop, turn the burner control knob to OFF
and wait five minutes to allow the gas to clear before you
try again.