General Control; Display - Schenck Process DISOMAT Opus Instructions De Service

English

2.3 General Control

2.3.1 Display

The display consists of an LC display with 20 characters.
After start-up, system is always in operating state (*) Weight Display; NET weight is
displayed (or GROSS weight if scale is not tared).
(*) Two operating states can be distinguished: 'Weight Display (Home Position)' and 'Menu Tree'.
You can also switch over the weight display (**) for an additional (alternating)
display of
•
Balance total
•
Date and time
•
Contact position (Inputs/Outputs)
(**) See BV-H2313: Chapter 'Home Position Output' and 'Fct. 55 Select Home Position'.
A legal-for-trade scale has to be operated in the weight display (=Net).
The display is used for showing
1. the weight measured including status information,
2. event messages,
3. the dialogs of the functions of the menu tree,
4. operator guidance or prompt for operator inputs
®
DISOMAT Opus – Operating Instructions
© Schenck Process GmbH, Darmstadt
General Control
0630 BV-H2322 AA
- 37 -