Connection Power Supply; Track Connection: Terminals J,K - Lenz Digital plus LV103 Mode D'emploi

Only one kind of power supply may be connected tot he
LZV200. Either a transformer or a power supply unit.

6.2 Connection power supply

As an alternative power connection you can use a commercially
available power supply. The pin diameter must be 2.5 mm. Plus and
minus do not have to be observed. The power supply should supply
min. 2.5 A and max. 5A.
The following values are permissible as input voltage:
with alternating voltage:
with pure DC voltage:
Make sure that you have connected only one type of power
supply. So either use a transformer OR a power supply.

6.3 Track connection: terminals J,K

Only use cables with sufficiently large cross-sections to connect the
tracks and then twist this cable (we recommend 0.25 mm
extended routes you need additional points of current supply at regular
intervals.
Fig. 2: Connection 2-wire tracks
min. 14 Volt, max. 19 Volt
min: 14 Volt, max. 24 Volt.
Fig. 3: Connection track with neutral wire
21
E
2
). For