Elcometer SAGOLA mack 150 Manuel D'utilisation page 36

5.- Turn the pressure regulator (No.5) clockwise until the product flows out of the product return
probe (No.03 Fig.3), thus returning the existing product inside the unit to its container or gravity
cup (No.01 Fig.1).
The unit is now ready to be immediately cleaned.
11. Maintenance
The unit must be overhauled on a periodic basis to check the status of its components and
replace these when they are not in perfect condition.
In order to obtain the best possible results, ALWAYS USE ORIGINAL
SAGOLA SPARES that guarantee total interchangeability, safety and
perfect operation.
In order to carry out maintenance or repairs, first disconnect the unit from the compressed air
distribution network.
Do not apply excessive force or inadequate tools for maintaining and cleaning the unit. Some
repairs must be done with special tools on some occasions. In these cases, you must contact
the Customer Service of SAGOLA. Do not use graphite greases as they dry out the joints, altering
their operation. Any handling of this product by non-authorised personnel would render the
warranty null and void.
11.1. Daily maintenance
1.- Flush the pump: Clean the pump unit after working and after any color change.
2.- Make sure there are no paint or air leaks: Check that the hoses are not damaged and that
all threaded connections are firmly tightened. Replace immediately if you find any anomalies.
3.- Visual oil inspection. Top up with Sagola PACKING OIL
(Ref.30090098), the cup if necessary.
Check that there are no products (solvents or paints, etc.) in the
oil. If so, check the tightness of the upper oil seal and replace it
if necessary, and change the oil.
11.2. Monthly maintenance
1.- Check the filter of absorption probe: Check about clogging or
damage of filter. Clean or replace, if it is necessary.
2.- Check the antipulsations paint filter: Check about clogging or
damage. Clean or replace, if it is necessary.
ENGLISH
Absortion
probe filter
A
ntipulsations
paint filter