Publicité
Press zone (
) and hold ( ) buttons simultaneously for 3 seconds, the
value will be displayed in temperature-zone of the display.
temperature-zone of the display.
Press up or down buttons to change the value settings Press the mode
(M) button or OK button to freeze the settings.
) button will NOT save the settings and normal
display screen will be displayed.
all other parameters.
6 = RS485
NOTE: If NUI CODE 100 = 3 the Heat pump will stop
(compressor only) when water set point is reached.
If NUI CODE 100 = 4 the Heat pump will turn off
(compressor and water pump) when air temperature set
point is reached on NUI.
3 sec
Enter par. Setting
Go to param. Nr.
Go to par. Value
numéro paramètre (réf. Tableau 1)
3 sec
valeur du paramètre
(réf. Tableau 1)
Change par. value
Save change
11
Publicité
