Lionelo BASTIAAN RWF Serie Manuel De L'utilisateur page 15

GROUPS II, II (15 – 36 kg)
For these weight groups, you have to disassemble 5-point belts of the child safety seat.
Mount the child safety seat in a forward-facing position.
1.
Place the child safety seat on the car seat.
2.
Put both ISOFIX pads (Z1) on fixing points of your car. Press ISOFIX buttons (Z) to
pull out the connecting arms (Y). Pull them out as far as you can, and then connect to
fixing points of your car. The latch indicator should be green.
Next take one of the steps below - a or b. Installation with ISOFIX handles only is prohibited!
A. ISOFIX + car belts (see: fig. 20).
1.
Place the child in the child safety seat.
2.
Pull the car safety belts.
3.
Carry the shoulder belt through the shoulder belt guide (A) and hip belt through the
hip belt guide (O).
Make sure the shoulder belt goes through the child's collar, not its neck.
4.
Fasten car safety belts.
5.
Tighten car safety belts.
B. ISOFIX + TOP TETHER + car belts
1.
Take step described in „a" concerning assembly with car belts. Make sure the shoulder
belt goes through the child's collar, not its neck.
2.
Pull out TOP TETHER fixing belt and next extend it with the use of adjustment (X).
Fasten the handle in the spot suggested in the vehicle manual (see: fig. 19). Tighten
TOP TETHER with the use of adjustment (X). The upper fixing belt is properly tightened
when you can see a green indicator in the buckle.
HOW TO MAINTAIN AND CLEAN
You can clean the cover in warm water with soap or soft detergent. Do not dry the cover in
the sun. Clean the buckle, child safety seat belts and plastic elements with warm water. Do
not use strong detergents. If you do not use the product, store it in a dark and dry place,
away from sunlight.
T
he pictures are for reference only. The real design of the products may differ from the pictures
The product has been tested and meets all the requirements of the: ECE R44.04
presented.
‑ 15 ‑ EN