Télécharger Imprimer la page

ecolight AC1067-WHG-06LF0-E Mode D'emploi page 3

Publicité

Les langues disponibles

Les langues disponibles

Assembly Instructions
5
6
Fig. 12
7
Once all the connections are made and the LED tape lights are in place, plug-in to
the power source and the lights are ready to use.
Troubleshooting Guide
Problem
Fixture doesn't light.
Fuse blows or circuit breaker
trips when light is turned on.
Care and Maintenance
IMPORTANT: This light fixture uses light emitting diodes (LEDs) to provide light. LEDs
do not have a filament to burn out like a traditional light bulb. LEDs gradually emit
less light over their lifetime, but will typically last 30,000 hours in a residential
environment.
Periodically clean the fixture and diffuser using a mild, non-abrasive cleaner and
soft cloth. When cleaning the fixture, make sure the power is turned off. Do not
spray cleaner directly onto any part of the fixture or LEDs.
Need Help?
In the event you are missing a part or have questions regarding installation
please visit our website at www.goodearthlighting.com/support or
call the Customer Care Center 1-800-291-8838, 8:30 a.m.-5 p.m., CST,
Monday-Friday.
The kit also contains corner connectors for navigating
Fig. 7
a tighter radius than the LED tape light can form to. Pry
the cover latch open with a small flathead screwdriver.
Insert the tip of the screwdriver into the gap between
the connector base and the latch and twist (Fig. 7). Once
the latch is open (Fig. 8), seat the LED tape light on top of
the contacts. Line up the "+" on the LED tape light
sections being connected (as shown) (Fig. 9). Close
down the latch until locked (Fig. 10). The contacts in the
Fig. 8
connector will pierce the contact plates in the LED tape
light sections. Repeat other side (Fig. 11).
Fig. 9
Fig. 10
Fig. 11
+
Remove the backing liner carefully as to not acciden-
tally peel away the clear sticky film used to mount the
LED tape light (Fig. 12) and place in desired position.
Carefully apply pressure to the entire length of the LED
tape light to ensure proper adhesion. The switch can be
affixed to the mounting surface or nearby wall with
double stick foam tape (not included). Once the tape
light is mounted, do not reposition it. Doing so will
reduce the adhesiveness of the tape backing.
Cause
Power is off.
Wall switch is defective.
The polarities across 1 or more
connections are reversed.
Discontinue use.
- 3 -
Solution
Check if power supply is on.
Replace switch.
Check the connections,
connect "+" to "+" and "-"
to "-".
Call customer service.

Publicité

loading

Ce manuel est également adapté pour:

Ac1067-whg-12lf0-e