Publicité
Les langues disponibles
Les langues disponibles
Important Safety Instructions
7. Additional LED tape light lengths CANNOT be added.
8. DO NOT plug the power cord into the power source until installation is
complete.
9. Reattaching the block connector and corner connectors multiple times
may result in damage to the tape light.
Dimmer Instructions
DO NOT USE THIS FIXTURE WITH A DIMMING CIRCUIT. If dimmer controls
are present, remove them and replace them with regular electrical switches.
If a three-way dimmer is present, replace it with a regular three-way switch.
If unfamiliar with electrical installations, it is recommended a qualified
electrician do the installation.
Assembly Instructions
NOTE: Measure the cut length of the LED tape light carefully before cutting to ensure
that the block connector and corner connectors do not need to be repositioned
multiple times as this may affect the performance of the tape light over time.
1
Select a location for the LED tape light and mark it. Verify that the power cord
reaches the nearest power outlet and will reach the LED tape light. Thoroughly
clean the mounting surface with rubbing alcohol and allow it to dry. DO NOT plug
the power cord into the power source until installation is complete.
2
3
4
-
+
–
The LED tape light is designed to be cut, based on
50 mm (~2 in.) incremental lengths (Fig. 1), allowing for
cornering or a more custom install. The LED tape light
can only be cut on the "cut symbol." Cutting elsewhere
will damage the LED tape light. Once cut, the LED tape
light can ONLY be joined together with either the block
connectoror the corner connectors.
Fig. 1
To connect the LED tape light to the power cord, line up
Fig. 2
the "+" located on the the leading end of the LED tape
light with the triangle molded on the power cord and
insert (Fig. 2).
Before connecting any partial or full sections of LED tape
Fig. 3
light, line up the polarity symbols. The polarity symbols
("+", "-") are located on the LED tape light every
300 mm (11.81 in.). All "+" are on one side and all "-" are
on the other side. To use the block connector, pry both
cover latches open with a small flathead screwdriver
(as shown). Insert the tip of the screwdriver into the
gaps between the connector base and the latches and
twist (Fig. 3). Once the latches are open (Fig. 4), seat the
Fig. 4
LED tape light sections on top of the contacts. Line up all
the "+" on the LED tape light sections being connected
on the same side (as shown) (Fig. 5). One at a time, close
down on the latches until they are locked (Fig. 6). The
contacts in the connector will pierce the contact plates
in the LED tape light to complete the connection.
Fig. 5
+
Fig. 6
A
- 2 -
Publicité
