Télécharger Imprimer la page

Chauvet Professional WELL PAD Manuel De Référence page 4

Publicité

Les langues disponibles
  • FR

Les langues disponibles

EN
Battery Charge Notes
This product is equipped with a built-in rechargeable lithium ion battery.
Avoid depleting the battery below 10%.
For best results, charge the battery in a temperature between 32 ºF (0 ºC), and 95 ºF (35 ºC).
When charging the battery, keep the product at least 1 m from any open flame or hot plate.
If the battery is completely discharged, the device cannot be turned on immediately when the charger is
connected. Allow a depleted battery to charge for a few minutes before turning on the device.
While charging, the device may heat up. This is normal and should not affect the device's lifespan or performance.
If the battery gets hotter than usual, the charger may stop charging.
When charging the battery, keep the charging case's cover open.
Always charge the battery with the product in an upright position.
Do not charge the battery for more than 24 hours.
CAUTION: The power button must be in the off position before placing the product in the charging
case.
Storage Notes
Recharge the battery to full capacity before storing the product.
Store charged product(s) in a dry environment, away from direct sunlight.
Mounting
Before mounting this product, read the
mounting clamps are capable of supporting the weight of the product. For our CHAUVET Professional line of mounting
clamps, go to http://trusst.com/products.
Mounting Diagram
Safety Cable
Safety Loop
Control Panel Description
Button
Function
<MENU>
Exits from the current menu or function
<ENTER>
Enables the currently displayed menu or sets the currently selected value into the selected function
<UP>
Navigates upwards through the menu list and increases the numeric value when in a function
<DOWN>
Navigates downwards through the menu list and decreases the numeric value when in a function
Passcode
After being prompted, enter the following passcode: <UP>, <DOWN>, <UP>, <DOWN>, <ENTER>.
This passcode cannot be changed and must be used whenever prompted.
3
QUICK REFERENCE GUIDE
Safety
Notes. Use at least one mounting point per product. Make sure the
Mounting Clamp
WELL Pad QRG Rev. 6

Publicité

loading