Maintenance And Storage - Haussmann GY 8205 59695008 Manuel De L'utilisateur

MAINTENANCE AND STORAGE

Maintenance and storage
Maintenance to be performed after each use
Prior to cleaning or any maintenance, always
ensure the power plug has been removed from
the electrical power supply.
When you have finished using the hand push
blower/vacuum always check to make sure that
the product is clean and free of dirt and debris.
This is important around the selector lever flap
which is just inside the round outlet. To check
this area, remove the collection bag and ensure
this area inside the outlet tube is free of debris
and dirt.
Operate the selector lever backwards and
forwards to ensure correct operation.
Store the hand push blower/vacuum in a dry
place, and out of reach of children.
Make sure all the nuts, bolts and screws are
firmly tightened to ensure the safe operation of
the device.
NOTE: REMOVE OBSTRUCTIONS FROM THE
VACUUM OPENING.
Twigs and long objects mat cause obstructions
to develop in the vacuum opening on the
bottom side of the vacuum unit. If this should be
the case, try to slightly shake the unit during
operation. If this should not solve the problem,
switch the unit off and pull the plug. Remove
the obstruction using the stick or another long,
thin object (don't use metal objects).
To avoid objects that caused an obstruction
from being repeatedly sucked in, it may be
necessary to move the unit slower over the
debris to be cleaned up.
Regularly check the collecting bags for signs of
wear and tear.
EN
Replace worn or damaged parts.
Only use original parts and accessories.
Do not hose or submerge any part of the
hand push blower/vacuum.
28
Do not use solvents to clean the hand push
blower/vacuum. Store the device in a dry place.
Note: Should the vacuum/blower function
switch become blocked, operate the switch
while unit is running. Turning the switch several
times while air is flowing through the unit
should remove the blockage. Make sure you are
not standing in front of the blower nozzle, when
you operate the switch.
Power cord maintenance
If the supply cord needs replacing, the task
must be carried out by the manufacturer, the
manufacturer's agent, or a power tool repair
centre in order to avoid a safety hazard.