Haussmann GY 8205 59695008 Manuel De L'utilisateur page 26

OPERATION INSTRUCTIONS
Unpacking
Due to modern mass production techniques, it
is unlikely that your power tool is faulty or that
a part is missing. If you find anything wrong, do
not operate the tool until the parts have been
replaced or the fault has been rectified. Failure
to do so could result in serious personal injury.
Mounting the handle (picture 1,2)
To mount the handle press the locking button
at the rear top of the hand push blower/vacuum
unit, pull the upper handle arm upwards until it
is fixed up and secured.
Adjusting the telescopic handle (picture 3,4)
Loosen the locking button and adjust the
telescopic handle to the desired length.
Make sure that locking button be fasten after
adjustment.
Attaching the collecting bag (picture 5,6,7)
1. Insert the lower two feet of the bags frame
into the supports at the rear end of the chassis.
2. Turn the bags frame into the correct position,
the bag should lock into place.
Working in vacuum mode (picture 8)
1. Make sure that the unit is switched off (on/off
switch in 'off' position).
2. Turn the function switch clockwise until the
arrow of the switch is aligned with the arrow of
the vacuum mode (VAC).
3. Switch on the device at the handle – always
stand in an upright position if you do so. Never
switch the device on, when you are kneeling or
sitting next to it.
EN
4. Vacuum waste by moving the vacuum unit
over the area you wish to clean.
Working in blower mode (picture 9)
1. Make sure that the hand push blower/vacuum
unit is switched off (on/off in position off ).
26
2. Turn the function switch anticlockwise until
the arrow of the switch is aligned with the arrow
of the blower mode (BLOW).
3. Blow debris away by moving forward with the
blower making sweeping movements.
4. Never blow debris into the direction of
onlookers.
5. Avoid moving the unit backwards over
unclean surfaces in blower mode.
Before starting
1. Make sure that the handle is properly
attached and is firmly seated in the chassis.
2. Always make sure that the collecting bag
is attached to the hand push blower/vacuum
unit before you switch on the device (both in
vacuum and blower mode).
3. Your hand push blower/vacuum unit is
controlled over the on/off switch at the handle.
Make sure the switch is in the off position.
4. Connect the unit to an extension cable. Lead
the extension cable through the handle and
around the strain relief.
5. Always direct the cable backwards away from
the device.
Note. If a cable should be damaged during
operation, switch the device off and disconnect
the mains cable from the mains supply. Do not
touch the cable before you interrupt the voltage
supply.
Note. Never carry the unit from the mains
supply.
WARNING. Disconnect the unit from the mains
supply: if you leave the unit alone, before
removing a blockage, before inspecting,
cleaning or other works at the unit, if the unit
vibrates abnormally.
Note. Operate the unit in daylight or sufficient
artificial lighting only.
Do not bend forward too far and always take