After Use; Maintenance; Periodic Maintenance - Greencut EBW700 Manuel D'utilisation

AFTER USE

Once you stop using the machine:
-
Turn off the machine and leave it on the floor.
-
Empty the fumigation tank and clean it.
-
If you have used liquid product, fill the tank with water, start the machine again and fumigate only with
water for one minute to ensure that all pipes are clean.
-
If dust has been used, start the machine with the tank empty and fumigate for a couple of minutes to
ensure that the ducts are well cleaned.

MAINTENANCE

Good maintenance will extend the life of the machine. Prolonged or constant use may require more intensive
maintenance for the machine to continue to function properly.
ATTENTION: Make sure the engine is completely shut down before performing any maintenance
or repair. This will eliminate any potential risk.
MAINTENANCE AND CARE AFTER USE
OVERALL CLEANLINESS
Mantenga la máquina limpia, especialmente la zona del depósito de combustible y las zonas cercanas al filtro del aire.
Mantenga su máquina limpia y en buenas condiciones.
Limpie las carcasas de su máquina con un trapo humedecido en agua. Nunca utilice gasolina, disolventes, detergentes,
agua o cualquier otro líquido para limpiar la máquina.

PERIODIC MAINTENANCE

Perform the following maintenance as often as indicated in the table below:
Operation
Air filter
Fuel filter
Spark plug
Cylinder fins
CLEANING THE AIR FILTER
Dirt in the air filter will cause a reduction in the performance of the machine. Check and clean this item. If you notice
damage or alterations in the filter replace it with a new one.
To clean the filter:
1. Remove the protective cover from the filter.
2. Remove the filter.
3. Dust from the outside of the filter can be cleaned by shaking the filter against a hard surface.
4. Clean the filter with soapy water.
Every 10 fuel
Every 2 fuel tanks
X
Once a year
tanks
X
X
X
65
EN