Greencut EBW700 Manuel D'utilisation page 62

62
Refueling the machine:
1. Choose a suitable area for this operation.
2. Shake the container in which you have the mixture of gasoline and oil already prepared.
3. Remove the fuel tank cap and refill with gasoline and oil mixture.
4. Close the fuel tank cap tightly and wipe off any fuel that may have spilled from the outside with a dry cloth.
WARNINGS:
• Stop the engine before refuelling, disconnect the spark plug and wait for the muffler to cool down.
• Do not start the machine in an enclosed room or enclosure. Exhaust gases, fuel vapours and chain oil contain
carbon monoxide and dangerous chemicals. In case of a concentration of gases produced by insufficient
ventilation, remove from the work area everything that impedes the flow of clean air to improve ventilation and
do not return to work in the area unless you have properly ventilated the area and are clear that the ventilation
is sufficient so that this concentration does not occur again.
• Do not refuel where flames, sparks or intense heat sources are present. Always refill the tank in well-ventilated
areas with the engine switched off. Do not overfill the fuel by trying to overfill the fuel tank. In case of fuel
leakage be sure to eliminate these leaks completely before starting, move the machine away from the spill area
and avoid any source of ignition until the vapors have dissipated.
• Separate yourself at least 3 metres from the area where you have refuelled before starting the machine.
• Do not use fuels such as ethanol or methanol. These fuels will damage the engine of the machine.
CHECK POINTS BEFORE COMMISSIONING
ATTENTION: Do not use this machine if it is damaged or incorrectly adjusted. Use this machine for
the purpose for which it was designed. Any other use can be dangerous for the user, for the
machine and for people, animals and things that may be around.
Check::
-
The machine completely and look for loose parts (screws, nuts, etc.) and damage.
-
No fuel leaks.
-
That the air filter is clean. Clean the filter if necessary.
Tighten, repair or replace as necessary before using the machine.
Do not use any accessories on this machine other than those recommended by us as their use could result in serious
injury to the user, the machine and persons, animals and things close to the machine.
COMMISSIONING
Before starting the machine, make sure that the moving parts of the machine are not in contact with any objects.
COLD ENGINE START
ATTENTION: Place the machine on a flat, stable surface to start it. Never attempt to start the
machine when it is on your back.
Make sure that the fumigation tube is not aimed at people, animals and plants before starting the
machine.
1. Place the fuel tap in the open position.
2. Place the throttle lever in the intermediate position.
3. Place the air lever in the closed position.