Publicité
Les langues disponibles
Les langues disponibles
REMOVAL OF WASTE CLIPPINGS
The tray should be emptied after every 50 operations to ensure no blockages occur.
TROUBLESHOOTING
This machine is fitted with a fuse, located between the mains switch and mains socket on the rear of
the machine. To replace the fuse;
• Isolate the machine from the mains supply.
• Open the fuse holder with a screwdriver blade.
The holder contains two fuses, the loose fuse is a spare.
• Insert a new fuse in the holder and replace the holder in to the machine.
NOTE: Always use the recommended fuse (120W / 2A) and DO NOT replace it with one of a
different rating.
Problem
No power
Not punching
Punched holes are not central
Machine will not punch
Punch holes are not parallel to
edge
Partial holes
Missing holes
Damaged hole edges
WORLDWIDE WARRANTY
Fellowes warrants all parts of the binder to be free of defects in mate-
rial and workmanship for 1 year from the date of purchase by the
original consumer. If any part is found to be defective during warranty
period, your sale and exclusive remedy will be repair or replacement,
at Fellowes' option and expense, of the defective part. This warranty
does not apply in cases of abuse, mishandling or unauthorised repair.
Any implied warranty, including that of merchantability or fitness for
particular purpose, is hereby limited in duration to the appropriate war-
405609_EUR_Orion_E_Manual_E_F_S_v2.4.indd 5
Cause
Machine is not switched on
Thermal cut-out switch has activated
Edge guide not set
Blockage
Debris is stuck below dies
Sheets not correctly aligned to punch
pattern
Selectable dies are not selected to punch
Possibly overloading the machine
ranty period set forth above. In no event shall Fellowes be liable for any
consequential damages attributable to this product. This warranty gives
you specific legal rights. You may have other legal rights that vary from
this warranty. The duration, terms and conditions of this warranty are
valid worldwide, except where different limitations, restrictions or condi-
tions may be required by local law. For more details or to obtain services
under this warranty, please contact Fellowes or your dealer.
Solution
Switch on machine at rear next to plug inlet and at the
socket
Allow machine to cool down for 30-60 minutes.
Adjust edge guide until hole pattern is correct
Check waste tray is empty. Check for blockage to paper
entry
Take stiff cardboard and slide into the paper entry. Move
the cardboard sideways to release any stray clippings into
the waste tray
Adjust edge guide and test punch scrap sheets until correct
Check the current dies are selected to punch holes. To
select a die, push selector switch down at the front
Punch plastic covers with paper sheets. Reduce number of
sheets being punched
5
1/19/2011 12:15:49 PM
Publicité
