Install The Middle Handle; Install The Chute Deflector; Install The Chute Control Rod; Install The Battery Pack - GreenWorks Pro SNC407 Manuel D'opérateur

EN
1. Align the holes in the middle handle (5) and the upper
handle (4).
2. Put the bolts (15) through the holes.
3. Tighten the handle knobs (16) onto the bolts (15).
4. Do the same operation on the other side.
7.3

INSTALL THE MIDDLE HANDLE

1. Align the holes in the middle handle (5) and the lower
handle (6).
2. Put the bolts (15) through the middle handle (5) and the
lower handle (6).
3. Tighten the handle knob (16) onto the bolt (35).
4. Repeat for left/right side.
7.4 INSTALL THE CHUTE
DEFLECTOR
12 12
20
19
1. Align the tabs (17) on to the slots (18) on one side first.
2. Once you have engaged one tab on one slot push until
you hear a click. Repeat on other side.
3. Push the chute deflector (12).
4. Make sure that the tabs (17) engage the slots (18) on the
two sides.
5. Make sure that the posts (19) engage the holes (20) on the
two sides.
5
6
16 35
17
18
English
7.5 INSTALL THE CHUTE CONTROL
ROD
23
1. Align the holes in the upper chute control rod (21) and
lower chute control rod (23).
2. Put the hitch pin (22) through the holes.
3. Align the arrows in the discharge chute and snow thrower
deck. Make sure the discharge chute faces forward.
4. Put the end of the chute control rod (3) straight through
the hole (19) in the bracket. Keep the grip handle down.
5. Push the chute control rod (21) into the hole (19) behind
the deck.
6. Turn the grip handle left and right to make sure that the
discharge chute moves in the same direction.
7.6

INSTALL THE BATTERY PACK

33
8
21
22
3
19
11