Frequency Channel; Trigger Modes; Integrated Sync Socket; Elinchrom Rx Features - Elinchrom EL-Skyport 19351 Mode D'emploi

Fig. 2 Frequency
channel selector
MODE switch
GROUP switch

Frequency Channel

Note:
Transmitter and the corresponding Transceivers RX or Universal Receivers must have
the same frequency channel setting !
Frequency Slide Button configuration
Channel
1
1 (default) Off
2 On
3 Off
4 On
5 Off
6 On
7 Off
8
On
Note :
After setting, switch Transmitter OFF and ON again to activate the new frequency channel change.
4
RX feature button
Power decrease
RX feature button
Power increase
OR modelling lamp
toggle
Flash Test
Flexible swivel
Antenna 360 ̊
Frequency
/ Mhz
2 3
Off Off 2456
Off Off 2458
On Off 2460
On Off 2462
Off On 2469
Off On 2471
On On 2473
On On 2475

Trigger Modes

The EL-Skyport Transmitter can trigger EL-Skyport Receiver modules
in the following modes:
1. Off è Unit is OFF
2. Select Grp - Group(1 to 4)
è Set switch to Grp. and select Group 1 to 4
è All corresponding EL-Skyport Receivers with the
same selected Group (1 to 4) are triggered
3. ALL
è Mode switch is set to ALL
è All corresponding EL-Skyport Receivers are triggered regardless of which Group is selected.

Integrated SYNC Socket

The integrated 2.5mm Mono Jack socket is for direct connection to the camera or lens

Elinchrom RX Features

If the EL-Skyport Transmitter is used with the latest EL-Skyport Transceivers RX, the
following EXTRA features are available:
Depending upon which Group is selected, The following RX-unit settings can be applied:
1. Power increase in 1/10 f-stops
è press push button + to increase the power of selected Group (or ALL) RX-units
in 1/10 f-stops
2. Power decrease in 1/10 f-stops
è press push button - to reduce the power of selected Group of (or ALL) RX-units
in 1/10 f-stops
3. Modelling lamp toggle
è press and hold the push button + longer than 2 seconds before release,
to toggle modelling lamp of the selected Group of (or ALL) RX-units.
5