Hayward TRX-20 Guide D'utilisation page 31

WHEEL OR BEARING REMOVAL & REPLACEMENT
4
1. Align a flat head screwdriver into the slot at the center of the wheel and pop out the
clip holding the wheel. 2. Remove the the clip holding the wheel and place it aside.
3. Remove the wheel hub (Rim). 4. (Only if bearing is worn) Remove the bearing by pushing it from the outside
to the inside of the wheel. 5. (Only if bearing is worn) Replace the bearing by pushing the new bearing from
the inside of the wheel until it bottoms out. MAKE SURE THAT THE FLAT PARTS OF BOTH THE BEARING AND
WHEEL HUB ALIGN. 6. Place the wheel hub back onto the TRX-20 body and take the clip and clip it
back in. Make sure you hear it clip. If not you didnt align the flat parts in step 5. When the unit is reassembled
turn the right front wheel (looking from behind) and make sure everything turns smoothly.
SKIRT AND INLET REMOVAL & REPLACEMENT
BEFORE YOU DO ANYTHING, TURN THE PUMP OFF. SUCTION CAN BE DANGEROUS!!!
2
1
1
1. Turn the unit upside down and press with both finders on both sides
of the inlet. While pushing down pull up on the inlet. 2. Remove the inlet.
4
3. Once the inlet is removed you can remove any debris that is in the
turbine chamber. You can also remove and replace the skirt/bracket
assemeblies. One of the middle skirt/brackets can be easily pulled out.
Once one assembly is out you can slide the others out easily to replace.
4. Once any debris has been removed or the skirts have been replaced
replace the inlet. Note it can only be inserted in one direction and once it is
in it should clip on both sides. Note: if it does not clip in then you have it
the wrong way around (it is marked L and R).
3
5
(can also be used to remove debris)
2
3
L R
CLICK
6
9