Publicité
Les langues disponibles
Les langues disponibles
OBJ_BUCH-0000000063-001.book Page 6 Wednesday, August 15, 2012 12:07 PM
en
6
en
Original Instructions for Vacuum Pump.
Symbols, abbreviations and terms used.
Symbol, character
Explanation
Make sure to read the enclosed documents such as the Instruction Manual and the General
Safety Instructions.
Before commencing this working step, pull the mains plug out of the socket. Otherwise there
may be danger of injury caused by unintentional starting of the vacuum pump.
Confirms the conformity of the vacuum pump with the Guidelines of the European Commu-
nity.
This sign indicates a possible dangerous situation that could cause severe or fatal injury.
WARNING
Worn out vacuum pumps and other electro-technical and electrical products should be col-
lected separately and sorted for environment-friendly recycling.
Product with basic insulation plus additional insulation on touchable, conductive parts con-
nected to the protective conductor.
Character
Unit of measure-
ment, international
P
W
1
U
V
f
Hz
Vol.
l/min
Vac.
bar
L x W x H
mm
kg
L
dB
pA
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
min, m/s
For your safety.
Read all safety warnings and all
WARNING
instructions. Failure to follow the
warnings and instructions may result in electric shock,
fire and/or serious injury.
Save all warnings and instructions for future reference.
Do not use this vacuum pump before you have
thoroughly read and completely understood this
Instruction Manual and the enclosed "General Safety
Instructions" (document number 3 41 30 054 06 1). The
documents mentioned should be kept for later use and
enclosed with the vacuum pump, should it be passed on or
sold.
Please also observe the relevant national industrial safety
regulations.
Intended use of the vacuum pump:
For holding drill units with magnetic foot on non-mag-
netic materials in weather-protected environments in
conjunction with the FEIN vacuum plate. The vacuum
pump is intended only for drawing in air and not for gases
or fluids.
Unit of measure-
ment, national
W
V
Hz
l/min
bar
mm
kg
dB
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
2
2
min, m/s
Special safety instructions.
Operate the vacuum pump only from socket outlets with
the earthing contact according to regulations. Only use
undamaged supply cords and regularly checked exten-
sion cords with earthing contact. A protective conductor
without continuity can lead to electric shock.
Convince yourself of the existence of the vacuum by
checking the reading on the manometer. Failure of the
vacuum can occur as a result of a mains failure or
because of thermal overload of the vacuum pump. Failure
of the vacuum can result in the complete unit falling
down.
Do not leave the switched on vacuum pump unattended.
Never subject a part of the human body to the vacuum.
The vacuum can cause injuries.
Check the connections, seals and hoses each time before
using. Have damage repaired only through a qualified
repair person and only using original FEIN replacement
parts. Prevent the hoses from being constricted, e.g.,
through debris, pinching or pulling. Lack of vacuum may
lead to failure of the holding device and lead to injury.
Explanation
Power input
Rated voltage
Frequency
Flow rate
Vacuum
Length x Width x Height
Weight according to EPTA-Procedure 01/2003
Sound pressure level
Basic and derived units of measurement from the
international system of units SI.
Publicité
