Publicité
UNPACKING
This product requires assembly.
Carefully remove the product and any accessories from
the box. Make sure that all items listed in the Packing
List are included.
WARNING:
Do not use this product if any parts in the Packing List
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.
Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
Do not discard the packing material until you have
carefully inspected and satisfactorily operated the
product.
If any parts are damaged or missing, please call
1-800-860-4050 for assistance.
PACKING LIST
Lawn Mower
Upper Handle Assembly
Upper Handle Lock Knobs (2)
Upper Handle Bolts (2)
Lower Handles (2)
Start Key
Mulching Plug
Grass Catcher
Operator's Manual
WARNING:
If any parts are damaged or missing, do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create
accessories not recommended for use with this product.
Any such alteration or modification is misuse and could
result in a hazardous condition leading to possible serious
personal injury.
ASSEMBLY
WARNING:
Do not insert start key or battery pack until assembly is
complete and you are ready to mow. Failure to comply
could result in accidental starting and possible serious
personal injury.
WARNING:
To prevent accidental starting, do not make any
adjustments or installations with the start key or battery
pack inserted. Accidental starting of the mower during
assembly could result in serious personal injury.
WARNING:
Never operate the mower without the proper safety
devices in place and working. Never operate the mower
with damaged safety devices. Operating the mower with
missing or damaged parts can result in serious personal
injury.
INSTALLING AND ADJUSTING HANDLE
ASSEMBLY
See Figures 2 - 3.
To install lower handles:
Insert the lower handle into the mounting hole on the deck
as shown.
Depress the lock button at the rear of the mounting hole
to allow the handle to slide into position.
NOTE: There are three height position notches that can
be adjusted by depressing the lock button and raising or
lowering the handle to the desired position.
Release the lock button to secure lower handle in place.
Repeat for other lower handle.
To install upper handle assembly:
Position the upper handle as shown and insert the bolt
through the matching holes at the bottom of the upper
handle and the top of the lower handle.
NOTE: The lower handle has two hole settings for height
adjustment. Make sure you use the same height setting
for each side.
Thread the upper handle lock knob onto the bolt.
Repeat for other side.
Pull up on the upper handle to raise it into operating po-
sition. Make sure that the upper handle is seated in the
grooves at the top of the lower handle.
6 — English
Publicité
Chapitres
Dépannage
