Setting - Sonnenkonig SLIM E 1000 Mode D'emploi

Mounting the wheels
1. Make sure that the heater is un-
plugged and the power switches
are turned off.
2. Turn the heater upside down.
3. Loosen the four screws at each end
of the heater base.
4. Locate the four footplate holes at
each end of the base of the heater.
5. Attach the footplates to the base
with the screws through the holes.
6. Place the heater upright and plug
it into a standard 220- 240 volt
outlet.

07 - SETTING

Remove the cover only when you want to make adjustments.
The cover is used to protect the control unit against water and dirt.
Control module
The function module is equipped with accurate thermal cut-off. It has a built-in memory with 12
heating programs, 9 of which are factory preset and 3 of which can be programmed by the user.
INFO: If the user pauses for more than 180 seconds while changing settings, the control module will
cancel the changed function without saving and return to the operation of the last selected heating
program.
Setting the day and time
When the heating panel is installed for the first time, switched off or disconnected from the mains, the day
and time must be set. To make changes to the LCD module settings, the cover must be removed by loose-
ning the single locking screw.
1. Press the Timer key
2. Use the „Up" and „Down"
3. Press the timer key
4. Select the correct hour with the „Up"
5. Press the timer key
6. Use the „Up" and „Down"
7. Press the Timer key
are saved.
Footplate
- the „Day" setting will flash.
keystoselectthe correct day.
- the „Hour" setting flashes.
and „Down"
- the „Minute" setting flashes.
keys to select the correct minute.
- the timer setting program is terminated and the selected day and time
keys.
Footplates Attach
and fasten rollers
EN
49