Assembly - Sonnenkonig SLIM E 1000 Mode D'emploi

06 - ASSEMBLY

Wall mounting
1. When wall mounting the heater, make
sure the heater is disconnected from the
wall outlet and all power switches are
turned off. A suitable wall mounting area
requires at least 150 mm of clearance on
ALL four sides.
3. Position the bracket in the desired
location on the wall and mark the holes
for drilling on the wall, making sure the
bracket is level. Drill the holes to an ap-
propriate depth and secure the bracket to
the wall with four appropriate mounting
screws. For masonry walls, use matching
anchors with screws.
EN
48
2. Disconnect the mounting bracket from the
back of the panel heater by pushing down
on the top bracket and then pulling out.
The lower section will then slide down
and out, releasing the mounting bracket.
4. Hook the heater into the brackets and
secure it; first place the heater on the
lower bracket and push it back to position
and click the upper brackets into place.
Check that the heater is firmly seated and
connect it to the power outlet.