Fein GRIT GIM Notice D'utilisation page 9

3 94 10 014 000 - Buch Seite 9 Mittwoch, 16. August 2006 1:26 13
GIM
Symbols, abbreviations and terms
used.
The symbols used in this Instruction Manual and
possibly on the wheeled carriage, serve to draw
your attention to possible hazards when work-
ing with the wheeled carriage.
Symbol Term, meaning
Action
Read documentation
General mandatory sign
Danger warning
For your safety.
Do not use this wheeled carriage before
you have thoroughly read and completely
understood this Instruction Manual, includ-
ing the figures, specifications and safety
regulations.
Read and observe the Instruction Manual
of the machine which is to be mounted on
this wheeled carriage.
This Instruction Manual should be kept for later
use and enclosed with the machine, should it be
passed on or sold.
Use appropriate fastening material when mount-
ing the machine to the wheeled carriage. When
mounted incorrectly, the machine can come
loose from the wheeled carriage and cause seri-
ous accidents.
Before switching on, ensure that all clamping
levers on the wheeled carriage are firmly tight-
ened. Sudden lowering of the machine during
the work procedure can lead to serious injuries.
Use safety glasses. The safety glasses must
be capable of protecting against flying par-
ticles generated by the various different
operations.
Wear additional safety equipment such as
steel cap work boots and safety gloves.
Danger of injury when unintentionally
touching the sanding/grinding belt during
the working procedure.
Work only on level surfaces. On inclined surfaces,
the machine can get out of control.
During the working process, always conduct the
extension cord away from the work location. Dan-
ger of an electrical shock when the mains cable
is driven over, pinched, crushed or damaged!
Pull out the mains plug for maintenance and
repair! Switching the machine on unintentionally
can lead to an electric shock.
At a glance.
1 Fastening bolt
2 Washer
3 Wheel
4 Axle
5 Locking screw for axle
6 Supporting surface
7 Fastening bolts for holding plate
8 Bolt
8a Bolt (belt grinder)
9 Holding plate
10 Fastening shaft
11 Locking screw for handle-bar adjustment
12 Handle bar
13 Fastening bolts for belt grinder (4x)
14 Safety switch (emergency OFF pushbutton)
15 On/Off switch
16 Crank for height adjustment of belt grinder
17 Cable tie
18 Electrical switchbox
19 Star-knob bolt for parallel adjustment
20 Star-knob locking bolt
21 Screw for depth stop
22 Screw for height stop
23 Crank for adjustment of the lowering/
lifting force
EN
9