Bamix Basic MW120 Mode D'emploi page 13

Cleaning and care
(
Always disconnect the device from the mains supply)
The bamix is very easy to clean. Remove the attachment and wash
®
it separately. To clean the attachment, rinse the dirty parts under
running water (do not switch on the appliance).
The easiest way to clean off bits of food which have stuck to the
bamix is to hold it in a jug with hot water and switch it on.
®
Take care that the switch of the bamix
with the water.
The appliance and the cutter guard are not suitab-
le for cleaning in the dishwasher. Corrosion (black
staining) may occur on the protective hood if it is
exposed to water for a longer time.
Important: Clean the appliance as soon as you have finished
working, to prevent the drive shaft or the attachment getting
clogged. If not in use, always remove the attachments from
the appliance.
To keep the bamix
months with vegetable oil.
Hold the bamix with the cutter guard facing up, lubricate the drive
®
shaft with 2-3 drops of oil and then run the appliance for approx.
30 seconds. Then clean the shaft with hot water.
What to do...
If the drive shaft of the appliance fails to rotate?
If the bamix is not used for a prolonged period of time, the drive
®
shaft might become stuck, or the attachment might slip from the
shaft stub, as the parts are clogged up by minute food residue.
Place the attachment for 5-10 minutes in a jug of hot water.
Then switch on the appliance. Normally, all parts should now work
perfectly again. If not, try to free the shaft carefully with pliers.
Assembling SwissLine stand
1. Insert front panel into the base
2. Slide cable holder into place
3. Mount flap for the storage of the attachments
24
does not come into contact
®
running smoothly for longer, lubricate it every few
®
Technical data (for power indications please see product overview)
Mechanical and EN 50564
electrical safety EN 55014-1
EN 55014-2
EN 60335-1
EN 60335-2-14
EN 61000-3-2
EN 61000-3-3
EN 62233
EN 63000
Directives and standards 2014/35/EG
2014/30/EU
2011/65/EU
2009/125/EG
10/2011/EG
94/62/EG
2012/19/EU
1935/2004 EG
Insulation Double insulation
Switch Safety switch with pulse contact
Intermittent operation max. 5 minutes at a time
All parts are made from rust-free, odourless and tasteless
Materials
materials that are resistant to corrosive foodstuffs.
Test marks
www.tuev-sued.de/ps-zert.
We herewith certify that this product and its attachments
Food contact
materials and accessories conform to the European Commission
Regulation No. 10/2011 on food contact materials.
It complies to all relevant statutory limits.
Disposal This product conforms to the European Directive 2012/19/EC
on waste electrical and electronic equipment – WEEE.
This Directive governs the disposal and recycling of such
equipment within the EU. For disposal instructions, please
contact your dealer or local authorities.
Manufacturer ESGE AG, Hauptstrasse 21, CH-9517 Mettlen/Schweiz
Made in Switzerland
All information in this document is subject to change without
prior notice. The above information might vary from country
to country.
www.bamix.com
LVD
EMC
RoHS
Freamwork Directive
PIM
Packing
WEEE
FMC
25