Troubleshooting - Reer BABYPHON MIDI FD-2600 Mode D'emploi

Problem / Situation
RECEIVER does not receive
any signals (without LED
display for range exceedance
and acoustic warning).
Humming or loud
whistling sounds.
Interference.
Limited operational range.
Problems recharging the
units.
LED display: Low battery ca-
pacity and acoustic warning.
Batteries are sufficiently
charged but the unit is not re-
sponding or is not functioning
properly.
page 19
3004.indb 19
All manuals and user guides at all-guides.com
possible malfunction source What can be done?
• SENDER does not send out • SENDER does not receive
any signals. any signals; RECEIVER and
• Range of baby and SENDER SENDER unit are in "Stand
unit exceeds range. By" mode.
• SENDER unit's sensitivity • Position SENDER unit closer
level is too low. to the baby.
• Change sensitivity level to
‚high', (See also „Sensiti
vity Level")
• Acoustic feedback; both • Position SENDER
units are positioned and RECEIVER unit further
too close together. apart or lower RECEIVER
• Volume is too high. volume
• Lower RECEIVER volume.
• Due to other Babyphone • Change the CHANNEL or
units within operational change CODE via DIP-
range. switch.
• Strong magnetic fields/ • Position units outside of
Shield from other metal magnetic fields.
components/ Motors too
close to the units.
• Concrete walls and ceilings. • Position SENDER
• Low battery power and RECEIVER unit closer
(LED flashes RED). together.
• Recharge batteries in both
units or connect adapters
to both units.
• Contacts are rusty or dirty. • Turn the units off and
• Units are not connected to clean the contacts with a
the adapters and adapters dry cloth. If contacts need
are not plugged into a wall to be replaced, please
outlet. contact our Service Center. contact our Service Center.
• Check if adapters are • Check if adapters are
plugged into the units and plugged into the units and
if the adapters are plugged if the adapters are plugged
into a wall outlet. into a wall outlet.
• Low battery capacity. • Recharge batteries of both • Recharge batteries of both
units or connect units and units or connect units and
adapters. adapters.
• Battery capacity is „too • Reset units by removing all • Reset units by removing all
low". batteries let the units rest for batteries let the units rest for
5 minutes. Turn the units back 5 minutes. Turn the units back
on and start operation. on and start operation.

Troubleshooting:

Before using the device for the first
time, please check the functional
efficiency (e.g. with the help of a
television). Now please carry out the
fine adjustment (sensitivity of the baby
unit, volume of the parent unit) and
make sure that an ideal transmission
is ensured. When doing so, please
take into consideration that a farther
distance and thick walls can have a
negative influence on the quality of
the transmission.
ATTENTION:
Under no circumstances should you
try to repair the devices on your
own because that would lead to the
expiration of the warranty.
30.04.2008 17:46:26