Functions Of The Terminals; Use Of The Reset Buttons - Fermax 5280 Manuel De L'utilisateur

Cod. 97842 V05_17

FUNCTIONS OF THE TERMINALS

Power 12Vdc
-
Test Power
Auto protection

USE OF THE RESET BUTTONS

3200290
Reset switch 1
Reset switch 2
Automatism
Open
Drain C No
Use this switch to restore the factory network settings (IP address:
192.168.2.150, mask 255.255.255.0).
Turn off the power.
Hold the switch down while turning the power back on
Wait until the relays engage (about 20 seconds) holding the switch down
Release the switch
Use this switch to clear the unit memory
Turn off the power.
Hold the switch down while turning the power back on
Wait until the relays engage (about 20 seconds) holding the switch down
Release the switch
Ethernet network
RS485
extension bus
License
Page 20/30
Nc Normally closed
C Common
No Normally open
+12 Vdc/1,5Amax.
+
S/CLOCK/DATA1/A S-BUS/CK / D1/A
DATAT/DATA0/B DT/DT0/B
LED LED
GND -
Push button Exit buttom
Door contact Door sensor
Conditional Conditional entry