Connecting The Ip_Axes 1/2+ Unit To An Ethernet Network - Fermax 5280 Manuel De L'utilisateur

Cod. 97842 V05_17

CONNECTING THE IP_AXES 1/2+ UNIT TO AN ETHERNET NETWORK

Each IP_AXES 1/2+ unit has an IP address. This address is printed on a sticker of the unit housing.
To configure a different IP address, you can use the "Automatic detection" menu in IP_AXES. To do
this, proceed as follows:
• After having created your installation, on first start up, IP_AXES offers to create a new unit
• Click on the "Search" button
• A list of detected units will appear
• Double click on the unit you want to add
• Check the equipment list to confirm that your unit is properly connected.
3200290
Crossed cable
Straight cable Straight cable
Page 18/30