Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
A typical setup when used as a DJ LED light modulator:
Just "daisy chain" the DMX in/outputs of all connected LED PAR projectors with the DMX-output of the
LEDCON-02 MK2 remote using a good quality balanced cable. You can connect up to 120 units! If you use
minimum 8 projectors, you can put the LEDCON-02 MK2 in 8channel mode.
ADDRESSING
Each time you build a different installation with the LEDCON-02 MK2, you should check the DMX addresses
of the connected projectors.
Important: LEDCON-02 MK2 can only work with projectors that have the following DMX-channel setup:
CH1= RED * CH2=GREEN * CH3=BLUE * CH4=DIM / STROBE
You can set the addresses on the connected projectors in 3 ways:
1. MANUAL ADDRESSING OF THE CONNECTED PROJECTORS:
Use this method with projectors that do not have our remote DMX-addressing function.
Set the DMX start addresses depending on the channel mode you have selected.
4CH MODE:
projector1 = address 001
Projector2 = address 005
Projector3 = address 009
Projector4 = address 013
8CH MODE:
Projector1 to 4: same addresses as for 4CH mode
Projector5 = address 017
Projector6 = address 021
Projector7 = address 025
Projector8 = address 029
2. FULL AUTOMATIC ADDRESS DISTRIBUTION :
Important: works only with projectors that are compatible with our remote DMX-addressing function.
The LEDCON-02 MK2 distributes the addresses automatically to all the connected LED projectors. The
first unit in the chain receives address 1, the next will have address 2, ... The address distribution
depends on the channel mode and the number of connected LED projectors. Some examples:
Set to 4 channel mode with 20 projectors addressing will be: 1234 – 1234 – 1234 – 1234 - 1234
Set to 8 channel mode with 20 projectors addressing will be: 12345678 – 12345678 - 1234
A. First determine if you will put the LEDCON-02 MK2 in 4 or 8 channel mode (see switch
n°12)
B. Connect all projectors to the LEDCON-02 MK2 and switch the complete setup on.
C. Press the "blackout" button (see n°8) for about 5seconds: until the red "blackout LED"
starts blinking.
JB SYSTEMS
®
5/39
OPERATION MANUAL
LEDCON-02 Mk2
Publicité
