Mitsubishi Electric CITY MULTI PEFY-P-NMLU-E Manuel D'installation page 5

[Fig.10.3.1]
[Fig.10.3.3]
To prevent external tensile force from applying to the wiring connec-
tion section of power source terminal bed use buffer bushing like PG
connection or the like.
Power source wiring
Tensile force
Use ordinary bushing
Transmission wiring
[Fig.10.3.5]
M1 M2 S
10.4
[Fig.10.4.1]
Terminal bed box connector (White)
Motor connector (White)
Attachment connector (Blue) (Accessory)
10.3
Screw holding cover (2pcs)
Cover
Terminal bed
Round terminal
Shield wire
Two shield wires may be connected together at the shield relay terminal bed
One shield wire is connected with another shield wire. (Terminal connection)
Insulation tape (for the earthing of shield and the prevention of contact to transmission terminal)
[Fig.10.3.2]
[Fig.10.3.4]
L1 L2
Power source terminal bed
Terminal bed for indoor transmission
To 1-phase power source
Transmission line DC 30 V
Terminal bed for outdoor transmission line (TB3)
Transmission line to the remote controller, terminal bed for indoor unit
and BC controller
10.5
[Fig.10.5.1]
<Address board>
Terminal bed box
Knockout hole
Remove
Knockout hole
G
M1 M2
5