KIDDY 46 Mode D'emploi page 9

5. Assembly and setup
Tools required: 5 mm hex wrench, 10 mm wrench
1. Press the switch located on the back of the fork and
insert the stem of the handlebar steering into the fork.
The switch should align with the positioning hole in the
handlebar stem and securely lock the stem in place.
2. Tighten the bolts using the 5 mm hex wrench and the 10
mm wrench. Tighten the bolts evenly and securely.
3. Align the handlebars both vertically and horizontally
(a) on the handlebar steering stem clamp (b), install the
handlebar clamp and components (c and d) and tighten
evenly and securely using the 5 mm hex wrench and the
10 mm wrench
07