KIDDY 46 Mode D'emploi page 6

• Fully charge the scooter before using it for the first time.
• Press the power switch located on the right side of the footrest.
• If the battery is low, recharge it before use. The electric scooter is a device that requires
periodic charging.
• Place the electric scooter on a flat surface.
• Place your hands on the handlebars. Step onto the footrest with one foot and use the other
to give yourself a gentle push and accelerate.
• When the electric scooter begins to move, place both feet on the footrest and press
the accelerator.
• To steer the electric scooter, tilt your body in the direction of travel when turning and slowly
turn the handlebar.
• To stop the electric scooter, release the accelerator and press the electronic brake or lever
on the left side of the handlebar.
• Stop the electric scooter completely before getting off. Trying to get off the electric scooter
while it is moving may result in injury.
• Once the power switch is set to "ON", the electric scooter will move when the throttle is rotated.
Before the throttle is rotated, make sure you are in an open area where it is safe to ride;
make sure you are balanced on the electric scooter, and have both hands on the
handlebar controls.
• Always make sure the power switch is set to "OFF" when the electric scooter is not in use.
Never store the product at a temperature that is near or below zero. Low temperatures will cause
permanent damage to the battery.
For your own safety, wear a helmet and knee pads to protect yourself against falls and injuries
while learning to ride the electric scooter.
The rider assumes all responsibility for any injury suffered when not wearing a helmet or other
protective gear.
2. Quick guide
04