Disinfecting Accessories (At Home); Overview - DTF MEDICAL kitett MINIKIT DUO Notice D'utilisation

Before fi rst use and after each use:
EN
• Disassemble each accessory, particularly all the parts of the valve and the protective membrane.
• Rinse all parts in contact with milk and the parts of the protective membrane in cold water (around 20°C).
• Next, clean in hot, soapy water.
• Rinse all the parts.
1 - For the valve:
Assemble the membrane on the
intermediate ring (making sure that
the valve is nested in the ring).
2 - For the protective membrane:
Assemble the
protective membrane.
Check that the white membrane is correctly positioned in its housing (press down on the edges to ensure a good seal
around the entire edge of the membrane).
3 - Reconnect the small tube to the protective membrane.
Allow to air dry on a paper towel or a clean cloth.
Repeat the operation on the second membrane and the second valve when using in double pumping mode.
NOTES:
• It is best to clean all parts in contact with breast milk immediately after use. This facilitates cleaning and prevents growth
of bacteria.
• If condensation appears in the small tube of the protective membrane or when milk enters inside, rinse the tube to remove
liquid residues.
• The protective membrane prevents any ingress of liquid into the tubing (long and intermediate) and into the device. It is
therefore important to clean it as soon as it is soiled.
WARNINGS:
• The tubing between the protective membranes and the selector and the tubing
between the selector and the device must not be cleaned or disinfected. Water
could remain in the tubing and damage the device.
• The selector must not be cleaned.
c. Disinfecting accessories (at home)
Accessories concerned:
1 - Breast shield
2 - Valve
3 - Protective membrane
4 - Collection container
5 - Cap
NOTES:
• Where intensive disinfection is used (premature babies or those with a weakened immune system), boiling water is the only
method that guarantees an optimal lifespan of the accessories.
• If disinfection takes place in boiling water and your water is hard, you can add a few drops of white vinegar (2 or 3 drops)
to avoid deposits on the walls of the parts.
• If disinfection is performed in a dishwasher, the plastic parts may be discoloured by food pigments. This does not impair
their functioning.
• Check the condition of the breast shields regularly during use, cleaning and disinfection.
D. Overview
Cleaning - Rinse in cold water (around 20°C), then clean
in warm soapy water and rinse the parts
Disinfection - Boiling water (10 minutes), dishwasher or
microwave steriliser
18
1
3 parts of the
For term babies (without medical problems), disinfect before fi rst use and once a day.
For premature babies or those with a weakened immune system, disinfect before fi rst use
and after each use.
• Disinfect all parts in boiling water (10 minutes), in the dishwasher or in a microwave steriliser.
* Refer to the manufacturer's data for the microwave sterilizer and do not exceed 1000 Watt.
• Allow to dry on a paper towel or on a clean cloth.
Before fi rst use and after each use
Before fi rst use and once a day
2 3