Kränzle VENTOS 50 ID Utilisation Et Entretien page 15

CLEANING AND
MAINTENANCE
DANGER:
Before performing any main-
tenance operation, unplug the
appliance from the electrical
socket.
Removing and replacing the paper
dust collection bag (if present)
- Release the levers (1 Fig. 1).
- Remove the cover (2 Fig. 2) complete
with motor unit and floater-holder (3 Fig.
2).
- Remove the polyester filter (5 Fig. 4).
- Remove the paper bag for collecting dust
(6 Fig. 4), and replace it as described
above.
- Reassemble all the parts by following the
dismantling process steps in the reverse
order.
Emptying the recovery tank
- Release the levers (1 Fig. 1).
- Remove the cover (2 Fig. 2) complete
with motor unit and floater-holder (3 Fig.
2).
- Remove the polyester filter (5 Fig. 4).
- Place it on the top of a drain and empty
the liquid in the recovery tank (23 Fig.
14).
- Clean the inside of the tank with running
water and then re-install everything doing
the opposite of the disassembly.
Daily cleaning
Checking and cleaning the polyester
filter (if present)
- Release the levers (1 Fig. 1).
- Remove the cover (2 Fig. 2) complete
with motor unit and floater-holder (3 Fig.
2).
- Remove the polyester filter (5 Fig. 4).
- Clean the filter (Fig. 17) from the inside
out with a blast of air; the filter can be
washed (Fig. 17) in warm water and must
only be replaced once it is completely
dry. If it is too dirty, replace it.
- Reassemble all the parts by following the
dismantling process steps in the reverse
order.
Cleaning the appliance
- Clean the unit body with a cloth damp-
ened with water or a mild detergent.
- Remove the top, as described above and
clean the inside with running water and
then empty it, as indicated above.
Replace everything doing the opposite of
the disassembly.
DANGER:
Do not wash the appliance us-
ing jets of water.
Periodic checks
Cleaning the cartridge filter
- Release the levers (1 Fig. 1) and remove
the cover (2 Fig. 2) complete with motor
unit.
- Loosen the knob (24 Fig. 15) and remove
the filter (25 Fig. 15).
- Clean the filter (25 Fig. 16) with a jet of air
from the inside outwards; the filter can be
washed (25 Fig. 16) in warm water. Re-
mount it only when it is completely dry,
replace it if it is too dirty.
- Re-mount everything, proceeding in the
opposite order to disassembly.
ENGLISH - 3