Publicité
Les langues disponibles
Les langues disponibles
-
Reassemble the polyester filter (5 Fig. 4).
-
Re-mount the floater-holder (3 Fig. 22),
with the "FRONT" arrow aligned with the
front part of the machine (9 Fig. 22); also
re-mount the cover (2 Fig. 22) and block
it via the levers (1 Fig. 1).
-
Insert, as far as possible, the sleeve (10
Fig. 6) of the suction hose into the nozzle
(11 Fig. 6) on the drum.
-
To release the sleeve (10 Fig. 6) press
and hold the button (12 Fig. 6) then pull
the sleeve outwards (10 Fig. 6).
-
Merge the flexible hose (13 Fig. 7) with
the extension (14 Fig. 7).
-
Connect the two rigid extensions (14-
15 Fig. 8) by aligning the two reference
points (16-17 Fig. 8).
-
Attach to the rigid extension (15 Fig. 9)
the desired accessory (vacuum nozzle,
the dust brush, the accessory for tight
spaces, the floor nozzle etc.).
Liquid suction
For appliances equipped with suitable acces-
sories.
-
Release the levers (1 Fig. 1).
-
Remove the cover (2 Fig. 2) complete
with the motor unit and floater-holder (3
Fig. 2).
-
Check for the Nylon filter (4 Fig. 3).
-
Remove the polyester filter (5 Fig. 4) if
present.
-
Remove the paper bag (6 Fig. 4) if pre-
sent.
-
Re-mount the floater-holder (3 Fig. 22),
with the "FRONT" arrow aligned with the
front part of the machine (9 Fig. 22); also
re-mount the cover (2 Fig. 22) and block
it via the levers (1 Fig. 1).
-
Insert, as far as possible, the sleeve (10
Fig. 6) of the suction hose into the nozzle
(11 Fig. 6) on the drum.
-
To release the sleeve (10 Fig. 6) press
and hold the button (12 Fig. 6) then pull
the sleeve outwards (10 Fig. 6).
-
Merge the flexible hose (13 Fig. 7) with
the extension (14 Fig. 7).
-
Connect the two rigid extensions (14-
15 Fig. 8) by aligning the two reference
points (16-17 Fig. 8).
-
Attach to the rigid extension (15 Fig. 9)
the desired accessory (vacuum nozzle,
floor nozzle etc.).
USING THE APPLICANCE
-
The device is equipped with wheels and
therefore can be moved easily.
-
To lift it up insert your fingers under the
dedicated handle (18 Fig. 10) on the top
of the cover.
Starting the appliance as a dust
suction device or liquid suction
device
-
Insert the plug (19 Fig. 11) into the sock-
et.
-
Push the switch (20 Fig. 12) on "I" to start
the suction motor; the switch lights up.
NOTES:
When the recovery tank is full, the noise
intensity increases and the device can no
longer aspire. Then you must switch off the
device and empty the tank as described in
the relevant paragraphs.
Switching off the appliance
-
Push the switch (20 Fig. 12) to the "0" po-
sition to stop the device; the lights will go
off.
-
Remove the plug (19 Fig. 11) from the
electrical socket.
-
Wind up the cable (21 Fig. 13) and hook
it onto its housing (22 Fig. 13).
ENGLISH - 2
Publicité
