REVAMP Professional LIBERATE CORDLESS HOLLYWOOD CURL Mode D'emploi page 3

• Whilst charging, the blue LED light of your autocurler, indicating the battery of the
device, will be flashing steadily. Once the blue LED light goes off, that means your
autocurler is fully charged and is ready for use.
Please note:
Your autocurler comes with a charging stand as well as a UK/EU charging adaptor and a
separate USB charging cable. You can charge your LIBERATE CORDLESS HOLLYWOOD CURL:
• using the UK/EU charging adaptor with the USB-C end plugged into the autocurler.
• using the UK/EU charging adaptor with the USB-C end plugged into the charging stand.
In this case, the blue LED light on the charging stand will remain static whilst the blue
LED light on the autocurler will flash until fully charged. Once fully charged, the blue
LED light on the autocurler will stay on for approximately 10 minutes and then goes off.
• using the USB charging cable plugged into any USB compatible device with the USB-C
end plugged into the autocurler.
• using the USB charging cable plugged into any USB compatible device with the USB-C
end plugged into the charging stand. In this case, the blue LED light on the charging
stand will remain static whilst the blue LED light on the autocurler will flash until
fully charged. Once fully charged, the blue LED light on the autocurler will stay on for
approximately 10 minutes and then goes off.
While styling your hair you can return your autocurler to the charging stand but please
note that the autocurler will only recharge when it has been turned off.
Warning:
• If the blue LED light of your autocurler, indicating the battery of the device, suddenly
starts to flash very rapidly then the appliance is faulty. If this happens, please stop
charging and remove the adaptor from the mains and contact our Customer Care
Centre for further advice.
INSTRUCTIONS FOR USE
• Before use, ensure the hair is clean, dry and tangle-free.
• For extra protection, apply a heat protection spray.
• Section the hair prior to styling. Style the lower layers first.
• Plug the product into a 100-240V mains power supply.
• Slide the POWER button
button for 2 seconds to switch on the product. The default temperature when the
product switches on is 180°C. There are 4 temperature settings 140°C, 160°C, 180°C, and
200°C, indicated by a white LED light according to the temperature selected.
• Press the temperature button again to select your desired temperature. The white LED
light indicating the temperature setting selected will gradually move up as you press
the temperature button.
• REVAMP recommends starting on the lowest setting on initial use and increase the
temperature until the desired result is achieved.
SETTING
Low
Medium Low
Medium
High
* type of curls recommended on normal hair
• The selected digital temperature display will flash until the autocurler has reached
the desired temperature. Once the temperature has been reached, the white LED light
will remain static and the audible beep means the product is ready to style. See table
above**
to the "on" position then press and hold the temperature
CURL TYPE (for normal hair)
Very loose curls
Loose curls
Regular curls
Tighter curls
TEMPERATURE
140°C
160°C
180°C
200°C