Mounting The Light - Waldman TYCOON DYP 228 Mode D'emploi

Instructions For Use Suspended Luminaire DYP 228(D), DYP 254(D) „TYCOON"
ENG
Mounting - Part 2
Fig. 11
11.1
11.2
11.3
11.4
11.8
11.7
11.5
11.6

Mounting the light

See also fig. 11.
f) Attach bracket [11.2] to junction
box [11.1].
g) Screw 1/4"-20 stud [11.3] into
bracket.
h) Run power cable [11.5] through
canopy [11.4].
j) Connect the light to the power
supply system as shown in fig.
3 on page 3.
k) Attach canopy [11.4] to the ceil-
ing by screwing cable gripper
[11.7] onto the stud [11.3].
l) Push strain relief [11.8] into the
canopy [11.4].
m) Run the wire rope [11.6] through
the guide bushing of the cable
gripper [11.7].
n) Adjust the wire rope to the
desired length. Note: To loosen
the wire rope, press the guide
bushing upward using a screw
driver.
Fig. 12
12.4
Aligning the light
Align the light head in such a way
that it is suspended horizontally in
all directions. If necessary, slightly
loosen the screw [12.5]. After
aligning the light, tighten the screw
again.
Fig. 13
12.5
11