Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6
maintenance
Check the dust collector and filters regularly to prevent any problems. Empty the dust collector when it is full and clean or replace
the filters when they are dirty.
EMPTYING AND CLEANING THE DUST COLLECTOR
Empty the dust collector after every use.
• Press the button [1] to unlock the dust collector and take it out of the vacuum cleaner.
• Hold the wide opening up and take with your thumb and index finger the complete filter system [2] out of the dust collector.
• Hold the dust collector upside down while holding it above a dust bin. To fully empty the dust collector, calmly shake it above the
dust bin.
• Clean the filters after every four times of emptying the dust collector:
• Open the filter system by carefully pulling the latch [3] [open] .
• Take the dark coloured filter [4] out of the holder.
• Clean the dark coloured filter [4] and the white filter [3] under lukewarm water and let them air dry completely. Do not use
any cleaning agents or brushes. Cleaning the filter will remove the dirt, but will not restore the original white color of the filter.
The color of the filter is not of any influence to the performance.
• Only assemble the filter system when all the filters are completely dry. You will hear a click when they are placed correctly.
• Place the filter system [2] back in the dust collector. It only fits in one way inside the dust collector.
1
Attentie
• Use the vacuum cleaner only when the filters are in place. If not, it can lead to loss of suction power or damage to the motor.
• Torn filters or filters that do not fit properly can cause damage to the engine. Replace a damaged filter by an original new one.
CLEANING THE TURBO BRUSH
Hair and /or other dirt can be stuck in the brush of the turbo brush. Therefore clean the turbo brush regularly to ensure effinciency
of the vacuum cleaner.
• Make sure the vacuum cleaner is switched off and and disconnect the turbo brush.
• Unlock the tab [5] at the bottom of the turbo brush with a coin or flat screwdriver and remove it.
• Carefully pull out the brush [6] .
• Clean the brush under lukewarm water and let the brush air dry.
• Place the brush back in the turbo brush.
• Replace the tab [5] and lock it with a coin or flat screwdriver.
20
•
English
6
5
2
5
4
3
Publicité
Table des Matières
