Adjust Telescopic Arm; Angling The Cutting Head; Switching On And Off; Working With The Equipment - Deltafox DG-CHT 1845 T Set Traduction De La Notice D'utilisation Originale

3. You can also adjust the height
of the carrying eye (9) on the
telescoping rod after loosening
the hex socket head screw (9a).

Adjust telescopic arm

The telescopic arm (6) can be continu-
ously adjusted via the quick release fas-
tener (7).
1. Fold the lever (7) forward
according to the image and
change the length of the arm by
pushing and pulling it.
2. Fold the lever (7) back and set
the desired working length of
the telescopic arm (6).

Angling the Cutting Head

To cut sloping edges or the top of the
hedge, the cutting head can be swivelled
into 11 positions.
Press the lock button (4) and
swivel the cutting head (2) at the
same time. It clicks into the desired
position when the lock button is
released.

Switching On and Off

Ensure that you are standing in a
firm position with both hands grip-
ping the hedge trimmer away from
the body. Ensure that the trimmer
is in contact with no other objects
before switching on.
1. Actuate the safety switch (
switch the device on with the on/off
switch ( 12). A lockable continuous
operation is not possible due to rea-
sons of safety.
2. If you release the on/off switch (
12), the device switches off again.

Working with the equipment

• If the blades become jammed with
solid objects, turn the device off im-
mediately, take out the rechargeable
battery, and remove the object.
• Always work away from the mains
power outlet. Set the cutting direction
before starting work. Ensure that the
power cable is kept well away from
the working area. Never lay the cable
over the hedge, where it could easily
be caught up in the trimmer blades.
• Do not use the unit if the blades are
blunt or worn. This will overstress the
11) and
motor and gearbox of the machine.
• Avoid overstraining the equipment
during work.
Do not use the unit when stand-
ing on a ladder or in an unsafe
position. Do not be tempted to
make unconsidered cuts. Doing
so may endanger both yourself
and others.
During cutting work, ensure that no
contact is made with objects, e.g.
such as wire fencing or main plant
stems. This may result in damage
to the cutter bar.
Always hold the equipment firmly
in both hands, with one hand on
the rear handle and the other on
the front handle. Thumbs and
fingers must be firmly around the
handles.
Observe the specified working
angle (60°±10°), in order to gua-
rantee safe working.
GB
57