Würth AFS 18 COMPACT Traduction Des Instructions De Service D'origine page 15

hazardous situation.
Keep handles and grasping surfaces dry, clean and free from
oil and grease. Slippery handles and grasping surfaces do not
allow for safe handling and control of the tool in unexpected
situations.
Battery tool use and care
A charger that is suitable for one type of battery pack may create
packs. Use of any other battery packs may create a risk of injury
When battery pack is not in use, keep it away from other
metal objects, like paper clips, coins, keys, nails, screws or
other small metal objects, that can make a connection from
one terminal to another. Shorting the battery terminals together
Under abusive conditions, liquid may be ejected from the
with water. If liquid contacts eyes, additionally seek medical
help. Liquid ejected from the battery may cause irritation or burns.
temperature.
cause explosion.
Follow all charging instructions and do not charge the battery
instructions. Charging improperly or at temperatures outside the
Service
using only identical replacement parts. This will ensure that the
safety of the power tool is maintained.
Never service damaged battery packs. Service of battery packs
should only be performed by the manufacturer or authorized
service providers.
Reciprocating Saw safety warnings
Hold the power tool by insulated gripping surfaces, when
performing an operation where the cutting accessory may
contact hidden wiring.
could give the operator an electric shock.
Use clamps or another practical way to secure and support
the workpiece to a stable platform. Holding the workpiece by
hand or against your body leaves it unstable and may lead to
loss of control.
Secure your workpiece with a clamping device. A workpiece
clamped with clamping devices or in a vice is held more secure
than by hand.
Always wait until the product has come to a complete stop
before placing it down. The tool insert can jam and lead to loss
of control over the power tool.
Do not open the battery. Danger of shortcircuiting.
Protect the battery against heat, e.g., against continuous
In case of damage and improper use of the battery, vapours
may be emitted. Provide for fresh air and seek medical help in
case of complaints. The vapours can irritate the respiratory system.
Use the battery only in conjunction with your Würth power
tool. This measure alone protects the battery against dangerous
overload.
Use only original Würth batteries with the voltage listed on
the nameplate of your power tool. When using other batteries,
e. g. imitations, reconditioned batteries or other brands, there is
danger of injury as well as property damage through exploding
batteries.
Use only original Würth accessories.
Residual Risks
Even when the product is used as prescribed, it is still impossible to
completely eliminate certain residual risk factors. The operator should
pay particular and additional attention to these points in order to
reduce the risk of serious personal injury.
Injury caused by vibration. Use the lowest speed setting which
achieves the cutting, limit exposure.
Injury caused by dust. Dust may enter the eyes or respiratory
system. Wear eye protection at all times. Wear appropriate dust
from the material being cut. Do not eat, drink, or smoke in the
work area. Ensure adequate ventilation.
Injury caused by electric shock. The blade may contact hidden
wiring, causing parts of the product to become live. Always hold
the product by the designated handles and take care when blind-
Injury caused by contact with the blade. The blades are very
sharp and will become hot during use. Wear gloves when
changing blades. Keep hands away from the cutting area at all
times. Clamp the workpiece whenever possible.
Injury caused by noise. Noise can damage hearing. When
using power tools for an extended period of time, wear hearing
protection.
Cordless Reciprocating Saw
Article number
Voltage
Stroke rate under no-load
Gear 1
Gear 2
Gear 3
Length of stroke
Cutting capacity
Wood
Metal
Pipe
Danger of explosion.
AFS 18 COMPACT
5701 412 000
18 V/DC
0 - 2000 min
-1
0 - 2600 min
-1
0 - 3200 min
-1
28.5 mm
250 mm
20 mm
130 mm
15