Uline H-5048 Mode D'emploi page 2

INTRODUCTION
MOTOR
Electric thru-flow vacuum motors must never be used in
applications in which wet or moist conditions are involved,
where dry chemicals or other volatile materials are present,
or where airflow may be restricted or blocked. Such motors
are designed to permit the vacuumed air to pass over the
electrical wiring to cool it. Therefore, any liquid (including
water), dry chemical, or other foreign substance that
would come in contact with electrial conductors could
cause combustion (depending on volatility) or electrical
shock. Failure to observe these precautions could result in
property damage and personal injury, including death in
extreme cases.
ELECTRICAL
Vacuum operates on 120 volt/60 Hz. Severe changes in
voltage, high or low, can cause damage to the motor and
cause premature motor failure.
This vacuum is equipped with a thermal protection shutoff
switch that cuts power if excessive operating temperatures
are detected. This may occur if there's a blocked vacuum
passage or clogged/full filters.
If thermal switch is tripped, immediately turn off
the vacuum, inspect for a blockage and verify the
condition of the filter bag. Replace or empty the
filter bag as required. The vacuum will require several
minutes to cool down to a safe operating temperature.
When cool enough, the thermal switch will reset and
user can resume normal use of the vacuum.
Use only manufacturer's replacement extension cord
or one that is properly sized for your application. Do not
use an extension cord with conductors smaller than 16
gauge (AWG) in size and make sure to only use a three-
wire outdoor extension cord provided with a three-prong
grounding plug and receptacle. To reduce power loss, use
a 14 AWG extension cord if longer than 50 ft. Extension
cord jacket type should be SJT or better. Extension cords
in poor condition or too small in wire size can pose fire
and shock hazards. To reduce the risk of these hazards, be
sure the cord is in good condition and that liquid does not
contact the connection.
PAGE 2 OF 24
SAFETY CONTINUED
GROUNDING INSTRUCTIONS
The vacuum must be grounded. If vacuum should
malfunction or stop working, grounding provides a path
of least resistance for electrical current, thereby reducing
the risk of electrical shock. This vacuum is equipped with
a cord that has an equipment-grounding conductor
and grounding plug. The plug must be inserted in an
appropriate outlet that is properly installed and grounded
in accordance with all local codes and ordinances.
Cutting off the ground wire or using a cord that is not
equipped with a ground plug will void the warranty of the
vacuum.
1. The vacuum is for use on a nominal 120-volt circuit,
and has a grounding plug. (See Figure 1)
Figure 1
WARNING! To reduce the risk of personal injury
due to a loose electrical connection between the
appliance's plug and extension cord, firmly and
fully attach the appliance plug to the extension
cord. Periodically check the connection while
operating to ensure it is fully attached. Do not
use an extension cord that provides a loose
connection. A loose connection may result in
overheating or fire and increases the risk of a burn.
To reduce the risk of disconnection of the vacuum
cord from the extension cord during operating:
Use the cord holder on the waist belt to secure
the extension cord to the vacuum plug as shown
on page 5, Figure 16 and described on page 5
under Operating The Vacuum, items 1 and 2.
Maintain appliance with care. Inspect extension
cords periodically and replace if damaged.
WARNING! Improper connection of the
equipment grounding conductor can result in a
risk of electrical shock. Check with a qualified
electrician or service person if unsure that the
outlet is properly grounded. Do not modify the
plug provided with the vacuum. If it will not fit
the outlet, have a proper outlet installed by a
qualified electrician.
Grounded
Outlet Box
Grounding Pin
Grounded
Outlets
0421 IH-5048