Chamberlain KLIK3U Mode D'emploi page 4

GARAGE DOOR OPENERS
Programming to a Genie
Before starting, you MUST have a Genie
door opener.
The images throughout this manual are for reference only and your product may look different.
1
Press the program button on the Universal Remote
Control until the LED turns on.
Program Button
3
Press the program button on the Universal Remote
Control.
Program Button
5
Release the Program/Set button and only the round LED
will be lit in BLUE.
7
On the Genie ® remote control, press and release the
button that is already programmed to the garage door
opener. Both LED's will flash PURPLE.
9
On the Universal Remote Control, press and release the
same button again. Both LED's on the garage door opener
will light up BLUE.
(continued)
® ®
Intellicode
® ®
Intellicode 2 remote control with at least one button already programmed to the garage
LED
2 Garage Door Opener
2
Select a button to program and press that button 5 times,
ensuring the LED stops flashing after each press.
4
On the garage door opener, press and hold the
Program/Set button until both the long and short LED
light up BLUE.
6
Press and release the Program/Set button and the long
LED will flash PURPLE.
8
On the Universal Remote Control, press and release the
same button you have already selected in step 2. Both
LEDs on the garage door opener will light up PURPLE.
10
On the Universal Remote Control, press and release the
same button again. This will activate the garage door
opener and programming is complete.
If the door does not activate, repeat the steps.
4