Publicité
Les langues disponibles
Les langues disponibles
NEED HELP?
The remote control will not program to a product with DIP switches.
•
Check the battery in the remote control. The LED should light when you press a button. Replace the battery if necessary.
•
If programming with 2 position DIP switches, reverse the DIP switches (OFF to ON and ON to OFF), then repeat the programming
steps.
•
For Chamberlain remote controls DO NOT use the "0" position, use "+" or "-". If you already have a 3-button remote, DIP switch #1
must be set to "-" if the large button is to open the door. It may be necessary to reprogram original remote controls.
•
Repeat the programming steps but make sure the LED stops flashing between each press of the remote control button.
•
Try programming using the Alternative Programming Option for products with a LEARN button.
The remote control will not program to a product with a LEARN button.
•
Check the battery in the remote control. The LED should light when you press a button. Replace the battery if necessary.
•
Repeat the programming steps but make sure the LED stops flashing between each press of the remote control button.
•
Try programming using the Alternative Programming Option for products with DIP switches.
The remote control LED will not light or it is dim.
•
Replace the battery.
The remote control LED does not activate the product until it is close to the product.
•
Replace the battery.
11
Publicité
