Danby DAC 12077EE Guide D'utiliser Et Soins De Propriètaire page 5

LOCATION
A) This room air conditioner is designed to fit easily into a single
or double hung window. However, since window designs vary, it
may be necessary to make some modifications for safe, proper
installation.
B) Make sure window and frame are structurally sound and free
from dry and rotted wood.
C) For maximum efficiency, install the air conditioner on a side
of the house or building which favours more shade than sunlight.
If the unit is in direct sunlight, it is advisable to provide an
awning over the unit.
D) Provide sufficient clearance around the cabinet to allow for
ample air circulation through the unit (See Fig. 2). The rear of the
unit should be outdoors and not in a garage nor inside a building.
Keep unit as far away as possible from obstacles/obstructions
and at least 30" above the floor or ground. Curtains and other
objects within a room should be prevented from blocking the
air flow.
E) Be certain the proper electrical outlet is within reach of the
installation. Use only a single outlet circuit rated at 15 amps.
All wiring should be in accordance with local and national
electrical codes.
F) DO NOT install unit where leakage of combustible gas is
suspected. Your air conditioner may fail to operate in air
containing oils (including machine oils), sulfide gas, near hot
springs, etc.
INSTALLATION
INSTRUCTIONS
1) Assembly of the Upper Channel to Cabinet.
• "L" Shaped Top Channel: Install the "L" shaped channel to the
top of the cabinet as shown in Fig. 3, using four (4) 3/8" screws.
2) Assembly of the Side Curtains to Cabinet.
• Extend the shutter from the shutter frame and slide it into the
shutter tabs on the side channel of the air conditioner, as shown
in Fig. 4.
• Slide the shutters into the top ("L" Shaped) and bottom ("U"
Shaped) channels. The shutters are identified (on frame) as left
and right.
INSTALLATION (cont'd)
4
20"
Min
30"
Side
Min
Obstruction
Ground
Fig. 2
Fig. 3
Shutter tabs
Shutter
Shutter frame
Awning
12" Min
20"
Min
Fence,
wall, or
other
obstacle
3/8" screws
"L" shaped
mounting bracket
"U" shaped Channel
(Factory Installed)
Fig. 4