Connect Electrical Supply; Check The Installation; Removing Appliance - AJ Madison CX491610 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Do not turn on the appliance until after the
silicone adhesive has completely dried (at least
24 hours, depending on room temperature).
9
CAUTION
Unsuitable silicone adhesive will cause natural
stone countertops to become permanently
discolored.

Connect Electrical Supply

9
CAUTION
Before installing, turn off at the service panel.
Lock service panel to prevent power from being
turned on accidentally.
9
CAUTION
To reduce the risk of electric shock and fire, do
not use a flexible power supply cord.
Refer to data plate for more information. See "Service"
for data plate location.
The branch-circuit breakers ampacity, the wire sizes
and the connections must be conform to the
requirements of the National Electrical Code or
Canadian Electrical Code and all local codes and
ordinances.
8
Attach flexible conduit to the junction box. Connect
the lead wires to the junction box supply wires in
proper phase:
black (L1) to black
red (L2) to red
green or bare to ground

Check the Installation

9
WARNING
Before you plug in an electrical cord or turn on
power supply, make sure all controls are in the
OFF position.
Remove everything from the cooktop surface. Clean
cooktop surface with cooktop cleaning creme.
Switch on the circuit breaker.
Verify that elements function properly.

Removing appliance

Disconnect the appliance from the power supply. For
flush-mounted appliances, remove the silicone joint.
Push out the appliance from below.
9
CAUTION
Damage to appliance! Don't lift device out from
above.

Publicité

Table des Matières
loading

Table des Matières