Prepare Installation Space - AJ Madison CX491610 Mode D'emploi

Prepare Installation Space

Create the cut-out in the countertop according to the
installation diagram. The angle of of the cut surface to
the countertop must be 90°.
The lateral cut-out edges must be flat in order to
ensure that the retaining springs are well-positioned
on the appliance. With multi-layered countertops,
secure strips laterally in the cut-out if necessary.
After creating cut-out, remove shavings. Seal cut
surfaces in a heat- and water-resistant manner.
Observe minimum distance between device underside
and furniture parts of /
3
The worktop must be reinforced if it is less than 20
mm thick when installed overlapping or less than
30 mm when installed flush. Otherwise, it is not stable
enough. The reinforced countertop must support at
least 60 kg (weight of cooktop, cookware and food
combined). Reinforcement material used must be
resistant to heat and moisture.



¡

[


“

“


“
 
“
PLQ


6
" (10 mm).
8
ƒ
PLQ

PLQ

PLQ


Flush mounting:
possible.




PLQ


The appliance can be installed in the following
temperature- and water-resistant countertops:
▯
Stone countertops
▯
Corian® or plastic countertops
▯
Solid wood countertops: Only in consultation with
the manufacturer of the countertop (seal cut-out
edges)
▯
Installation in other countertops only in
consultation with the manufacturer of the
countertop.
Installation in countertops made of particleboard isn't
possible.
NOTICE: The flatness of the cooktop should only be
checked after insertion in the gap for the built-in unit.
PP
Flush mounting into a countertop is
U 
U  





“

“
PLQ








“
 
“
PLQ 


 
PLQ


PP