Waldbeck Ventura Mode D'emploi page 22

EN
22
2. Place the fork (13) on the front axle bracket (10) by inserting the screws of
the fork through the holes of the axle bracket (10)
3. Place one end of the middle axle guide (11) on the floor (1) and the other
end on the front axle bracket (10). Align the holes of the front axle bracket
(10), the middle axle guide (front) and the fork (13) and insert M8x25
screws through them from below. Place washers over the threads of the
screw (M8) from above and fasten M8 nuts (17) over them. Mount the
other end with 2 sets of M8x18 screws, M8 washers and nuts (16).