Waldbeck Ventura Mode D'emploi page 21

4. Align the holes on the flat ends of the left side of the rear axle guide (9)
with the holes on the base (1). Insert the screws (16) from the bottom of
the floor into the flush aligned holes. Place a washer (16) over the bolts
and screw a nut (16) on top of each.
ASSEMBLING THE FRONT AXLE
1. Attach front axle bracket (10) to front floor (1). Align the holes. Place a
washer (16) over the screws and screw a nut (16) onto each thread.
EN
21